179 - Horn bolts were trimmed flush.
180 - Left aileron servo and pushrod assembly completed.
181 - Installing the right side pushrod. Note the horn did need to be drilled to accept the pushrod.
182 - Aileron control completed.
183 - Tow hook made from extra rod and installed in pre-drilled location.
184 - Wing bolts installed.
185 - Aileron servos hooked up to the receiver.
186 - Wing leading edge dowels plugged into front of fuselage.
187 - Wing mounted to fuselage.
188 - Wing assembled.
189 - Cutting out the canopy. It was scored with a razor.
190 - Canopy cut out along score marks.
191 - Canopy sanded and shaped.
192 - Canopy finished and ready to install.
193 - Canopy placed on fuselage for size. It will be permanently mounted later.
194 - HET-RC Sniper basic construction completed.
195 - Elevator throws are as follows:
High Rates: UP 8mm / DOWN 6mm
Low Rates: UP 5.5mm / DOWN 4mm
196 - Aileron Throws:
High Rates: LEFT/RIGHT 8mm / DOWN 6mm
Low Rates: LEFT/RIGHT 6mm / DOWN 4mm
197 - The C/G (Center of Gravity) point is 90mm from the base of the leading edge of the wing.
You may opt to move it forward or back, but based on our findings 90mm is the best starting point.
198 - Bottom painted flat white.
(NEXT PAGE)